Harken UNIT 1 Manuel D'instructions page 40

Assembly
5
In this step, the halyard swivel, feeder and torque tube are attached to the foil.
Norseman/Sta-Lok Instructions
After the swivel and torque tube have been placed on the wire
you must install the Norseman or Sta-Lok stud. See pages 26
and 27 for details. For easier installation, push the bottom foil
completely over the bottom connector to expose as much wire
as possible. After the terminal is attached, secure the
bottom foil as described in Step 4.
November 2001
Slip the halyard swivel onto the foil and up past the 1
(48 mm) gap in the foils.
The halyard swivel has a "top" and a "bottom" and
must be placed on the foil with the long hooked
tang facing up.
NORSEMAN, STA-LOK OR ROD - refer to special
instructions below before proceeding.
Attach the feeder to the gap in the foils. Use blue Loctite
on the screw. The end of the feeder with the screw
should be at the bottom of the gap.
Tip: The feeder uses a "loose hinge." Place the half with the pin sock-
ets into place on the exposed connector, slip the half with the pins
into the sockets and snap it shut.
Remove the two torque tube screws and slip the tube
onto the foil, narrow end up and secure it by insert-
ing the red stud cap against the flat side of the foil.
Alternatively, you can also use duct tape.
Rod Instructions
After the swivel, feeder and torque tube have been attached
per the above instructions, you must attach the rod adapter
stud to the rod. See page 27 for details.
Unit 1 MKIII
/ "
7
8
20