Features; Assembly; Operation - RIDGID R86034 Manuel D'utilisation

FEATURES

PRODUCT SPECIFICATIONS
Coupler ...............................................................1/4 in. Hex
Switch .............................. VSR (Variable Speed Reversible)
No Load Speed ..................................0-2,400 r/min. (RPM)

ASSEMBLY

WARNING:
Do not use this product if it is not completely
assembled or if any parts appear to be missing or
damaged. Use of a product that is not properly and
completely assembled or with damaged or missing
parts could result in serious personal injury.
If any parts are damaged or missing, please call 1-866-539-1710 for assistance.

OPERATION

WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a
second is sufficient to inflict severe injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1 along with
hearing protection. Failure to do so could result
in objects being thrown into your eyes and other
possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product.
The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Driving screws, lag bolts
 Tightening nuts and bolts
 Removing screws, nuts, and bolts
Impact Speed* ................................................. 0-3,100 IPM
Torque ................................................................ 1,750 in.lb.
* Impacts per minute.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended
for use with this product. Any such alteration
or modification is misuse and could result in a
hazardous condition leading to possible serious
personal injury.
LED GRIP LIGHT
See Figure 1, page 8.
The LED light switch is located on the handle of the tool.
The LED light, located on the front of the tool base, illumi-
nates when either the switch trigger or grip light switch is
depressed.
If the tool is not in use, the time-out feature will cause the
light to start fading and then shut off.
The LED light illuminates only when there is a charged bat-
tery pack in the tool.
SWITCH TRIGGER
See Figure 1, page 8.
To turn the impact driver ON, depress the switch trigger. To
turn it OFF, release the switch trigger.
VARIABLE SPEED
See Figure 1, page 8.
This tool has a variable speed switch that delivers higher
speed with increased trigger pressure. Speed is controlled
by the amount of switch trigger depression.
NOTE: You might hear a whistling or ringing noise from the
switch during use. Do not be concerned; this is a normal
part of the switch function.
NOTE: Running at low speeds under constant usage may
cause the tool to become overheated. If this occurs, cool the
tool by running it without a load and at full speed.
5 - English