THOMSON MWGT263XD Manuel D'utilisation page 52

EN
2/INSTALLING YOUR APPLIANCE
TURNTABLE INSTALLATION
Hub (underside)
Glass tray
Turntable shaft
Turntable ring assembly
COUNTERTOP INSTALLATION
Remove all packing material and accessories. Examine the oven for any damage such as
dents or broken door. Do not install if oven is damaged.
Cabinet: Remove any protective film found on the microwave oven cabinet surface. Do not
remove the light brown Mica cover that is attached to the oven cavity to protect the
magnetron.
INSTALLATION
1. Select a level surface that provide
enough open space for the intakeand/or
outlet vents (no built in).
A minimum clearance of 3.0 inches (7.5cm) is
required between the oven and any adjacent
walls. One side must be open.
(1) Leave a minimum clearance of 12 inches
(30cm) above the oven.
(2) Do not remove the legs from the bottom
of the oven.
(3) Blocking the intake and/or outlet openings
can damage the oven.
30 cm
OPEN
7.5 cm
7.5 cm
a. Never place the glass tray upside down.
The glass tray should never be res-
tricted.
b. Both glass tray and turntable ring
assembly must always be used during
cooking.
c. All food and containers of food are always
placed on the glass tray for cooking.
d. If glass tray or turntable ring assembly
cracks or breaks, contact your nearest
authorized service center.
2. Electrical connection
• Your installation must be protected by a
16 Amp thermal fuse.
• It is mandatory to use a power point with
a ground terminal, connected in accordance
with current safety regulations.
• In your electrical installation, provide a device
that is accessible to the installer, capable
of separating the appliance from the mains
power and whose contact opening is at least
3 mm at all of the poles.
• If the sypply cord is damaged, it must be
replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoir
a hazard.
WARNING: Do not install oven over a range
cooktop or other heat-producing appliance.
If installed near or over a heat source, the
oven could be damaged and the warranty
would be void.
The accessible surface may be
hot during operation.
10