Venga VG RVC 3000 BK Mode D'emploi page 8

ENGLISH
EN
QUICK START
Plug in the charging dock, and place the remaining
excess cable into the cable storage space at the bottom
of charging dock.
Note: if you don't put the excess cable into the
storage space, it may get tangled with the robot while
charging or cleaning.
Charging dock position
Install side brushes
Attach side brushes to the bottom
of the robot by pressing a brush
into each slot.
8 - VG RVC 3000
VG RVC 3000_[IB]-7L_NEW.indd 8 VG RVC 3000_[IB]-7L_NEW.indd 8
Place the charging dock on a hard, level
surface and against a wall.
Make sure the area around the charging dock
is open and uncluttered, leaving at least:
• 2 m / 6 ft in front.
• 1 m / 3 ft on both sides.
Install the charging dock in a location
that your Venga! robot can easily access.
Always keep the charging dock plugged in.
Remove the bumper protectors and
turn on the main power switch on the
bottom of the robot.
16/06/22 13:24 16/06/22 13:24