Brandson Equipment 305385 Mode D'emploi page 48

The flashing alert symbol indicates whether the alert is low or high.
Press any button to stop the alarm sound.
The alert symbol flashes as long as the value is in the alert range.
Note: To permanently turn off the alarm, open the weather display
mode, go to the item you want to turn off, and press the SETTINGS but-
ton to switch it OFF.
13. Cleaning
Cleaning the rain collector
1. Unscrew the rain collector by rotating it counter-clockwise by 30° (in
the direction of the "Unlock" symbol).
2. Remove the rain collector carefully.
3. Clean it and remove any debris or insects.
4. Replace the collector when it is clean and completely dry.
Cleaning the hygro-thermal sensor
1. Remove the two screws at the bottom of the guard.
2. Remove the safety guard carefully.
3. Carefully remove any dirt or insects on the sensor housing. Do not
allow the sensors inside to become wet.
4. Clean the shield with water to remove dirt and insects.
5. Replace all the parts when they are clean and completely dry.
48
English