Kohler K-15135 Mode D'emploi page 3

Threaded Spouts
Apply
plumbers
putty.
Nipple
4"
(102 mm)
Standard Length Spouts
2. Install the Threaded Spout
NOTE: The following instructions are for threaded spout
installations only. For slip-fit spout installations, proceed to the next
section.
Remove the temporary nipple.
If you are installing the standard spout, apply thread sealant and
install a 1/2" NPT nipple, extending 4" (102 mm) beyond the
finished wall, to the bath elbow.
If you are installing the 8" (203 mm) spout, apply thread sealant
and install a 1/2" NPT nipple, extending 7-1/8" (181 mm) beyond
the finished wall, to the bath elbow.
Apply a bead of plumbers putty or other sealant to the back of
the escutcheon according to the manufacturer's instructions.
Apply thread sealant to the nipple, and install the spout to the
nipple.
Carefully tighten with a clean strap wrench.
Remove any excess putty.
Kohler Co.
Apply
plumbers
putty.
Nipple
7-1/8"
(181 mm)
Large Spouts
3 1011610-2-D