Publicité
GB
CHANGE OF SIZE (fig. f8-f9-f10-f11)
The riveting tool is supplied with 6 pairs of threaded tie-rods
(A), heads (B), entreiners (R) and, spacers (S) only for tie-
rods from M4 to M6 (f8).
To change the size make as follows:
• Disconnect the compressed air feeding from the tool.
• Unscrew the cone-carrying head (O) by a 22 mm standard
spanner (f9).
• Extract the threaded tie-rod, pushing and lifting it at the
same time (f10).
• After preparing the threaded tie-rod (A) of the size you
need, arrange and keep the components as shown in f11
and assemble. Be sure that the components are correctly
placed, rotating the tie-rod by hand (f11).
ATTENTION!
• The side of the component (R) to be entered in the head
of the tie-rod is provided of a magnet to avoid accidental
fall during the operations of change of size.
• Screw the cone carrying heads (O) by a 22 mm standard
spanner and clamp correctly.
ATTENTION!
Disconnect the machine before carrying out the
above-mentioned operations.
f8
M4 ÷ M6
A
B
f9
22 mm
O
34
M8 - M12
R
S
A
B
75036127 - KJ 73 – rev 00 - ( 01-2020 )
f10
f11
R
KJ 73
Publicité
