Telescopic Pole (Not Included) Assembly; Operation - Kokido TELSA 10 Manuel D'emploi

Telescopic pole assembly
Note: V-clip is installed inside the pole connector for the purpose of securing the
telescopic pole (not included) in position. Slide the telescopic pole onto the pole
connector. Press on the side pins of the connector and slide the telescopic pole
further until the pins are secured inside the holes of the pole.
To release the telescopic pole, press down the side tabs simultaneously and pull out
the pole.

OPERATION

WARNING!
Do not use the pool vacuum if any damage is detected.
Oil stain could occur due to possible leakage of lubricants applied to the O-ring.
Do not operate this pool vacuum if there are people/pets present in the water.
Make sure the pool vacuum is fully immersed in the water before initiating operation.
The minimum water level required to operate the device must reach above the
power button of the pool vacuum when it is held in a vertical position. Operating the
pool vacuum when not immersed in the water correctly can damage the unit and
the warranty will be voided as a result.
Maximum operating depth in water is 2 meters (6.5 ft).
Maximum water temperature: 5˚C (41˚F) –35˚C (95˚F)
DO NOT use the pool vacuum without an intact filter bag in place. Using your pool
vacuum without an intact filter bag in place will VOID your warranty.
Suction entrapment hazard: This pool vacuum generates suction. Do not allow hair,
body or any loose parts of your clothing to make contact with the suction mouth of
the pool vacuum during its operation.
Never insert body parts, clothing or other objects into the openings and moving
parts.
DO NOT use this pool vacuum to pick up any toxic substance, flammable or
combustible liquids such as gasoline, or operate in the presence of explosive or
10