Set-Up Before Use; Pole Connector Assembly; Brush Assembly; Pole Assembly - Kokido TELSA 10 Manuel D'emploi

Normally, the pool vacuum can be operated up to 40 minutes on a full charge
(charged for 4-5 hours)
Note: Clean the filter regularly. Too much debris inside the filter will increase burden
to the motor operation and then shorten the operating duration.
FACT: Rechargeable lithium-Ion battery is classified as a consumable item. It has a
limited life and will gradually lose its capacity to hold a charge. Therefore, running
time of the pool vacuum will gradually reduce through repeated charging and
discharging in operation.
NOTE: Let the pool vacuum rest for 30 to 40 minutes before charging it again.

Set-Up Before Use

Pole connector assembly

Press down the side pins of the connector and insert it inside the main body. Turn the
connector in either direction until the pin is secured in the hole, as shown in the
diagram .

Brush assembly

Align and push the brush into the notch on the front cover.

Pole assembly

Select the tube section with a threaded tip at the end. Insert and the threaded tip of
the pole section inside the pole connector and turn it clockwise to screw it inside.
Finish the assembly by inserting the grooved ends of the following section tubes in
the round ends of the remaining section tubes. The section with the grip is the last
section to be assembled.
9