Getting Started; Charging The Battery - Kokido TELSA 10 Manuel D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

leave the pool vacuum plugged in for long-term storage. Recharge the
pool vacuum every three months.
Above warnings and cautions are not intended to incorporate all possible
instances for risks and / or severe injuries. Pool / spa owners should always
exercise extra caution and common sense when utilizing the product.

GETTING STARTED

IMPORTANT NOTE: Fully charge the pool vacuum before using it for the first time.

Charging the battery

WARNING!
Charging must be done indoors, in a well-ventilated area away from sunlight,
children, heat, ignition sources, and with an ambient temperature between 5˚C (41˚F)
and 30˚C (86˚F).
Never use the external adaptor and charging base if any damage is detected.
Use only the original external adaptor provided.
Make sure the pool vacuum and the charging base are clean and dry before set-up.
Place the unit on a flat surface. Open the protective cap on the end of the body and
align the 2 pins of the charger base above the charging sockets. WARNING! Make
sure not to invert the position of the charger base. Press the charger base onto the
rear body until it the pins are inserted completely into the sockets. Plug the female
jack of the external adaptor into the charging port at the end of the charging base.
7

Publicité

Table des Matières
loading

Table des Matières