Cleco mPro400GCD-S Mode D'emploi page 6

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

1
EN
2.5 Personal Protective Equipment
(PPE)
 When working with rotating parts, it is not permitted to
wear gloves.
Recommendation: Freely rotating u-GUARD pro-
tected fastening tools are available from APEX.
 Wear close-fitting clothing.
 Wear safety shoes.
 If necessary, wear a hairnet.
 Wear protective goggles, if there is a risk of flying
debris or parts being elected.
2.6 Warnings and Notes
Warning notes are identified by a signal word and picto-
gram:
Signal word: describes the severity and the probability
of the impending danger.
Pictogram: describes the type of danger.
Danger
Symbol combined with the word Danger in-
dicates a hazard with a high level of risk
which, if not avoided, will result in death or
serious injury.
Warning
Symbol combined with the word Warning
indicates a hazard with a medium level of
risk which, if not avoided, could result in
death or serious injury.
Caution
Symbol combined with the word Caution in-
dicates a hazard with a low level of risk
which, if not avoided, could result in minor or
moderate injuries or environmental dam-
age.
Note
An symbol combined with the word Note in-
dicates a potentially harmful situation which,
if not avoided, could result in damage to
property or the environment.
General notes
includes application tips and useful infor-
mation, but no hazard warnings.
6
2.7 Symbols on the Product
Be sure to understand the meaning of each symbol below
prior to installation, operation or maintenance service.
Electrical voltage
CE compliant
The product corresponds to the prescribed
technical requirements in Europe.
Read all instructions.
NRTL TÜV SÜD Mark
WARNING
2.8 System Relevant Safety
Instructions
Follow national, state and local safety and connection stan-
dards during installation. The standards take precedence
over the information in this section.
 Do not make any modifications to the controller, pro-
tective devices, or accessories without prior written
authorization from Apex Tool Group.
 Do not attempt to open the controller or components of
the controller for troubleshooting or other work on the
device. In the event of a fault, any intervention can
result in serious injury from electric shock.
Operation with the device open may also cause the fol-
lowing:
-
An increased amount of emissions: may produce
interference with other devices.
-
Reduced immunity from interference: may produce
faulty results.
-
Loss of remaining warranty period.
Risk Of Injury Due To Electric Shock
The controller and tool can conduct current in the event of
a fault. An electric shock can lead to cardiac arrest, cessa-
tion of breathing, burns, and serious or fatal injuries.
P2349HW | 2019-08
Normative references, Page 9
Disconnect mains before opening
controller.
Apex Tool Group

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mpro400gcd-sh

Table des Matières