Notes On This Description; Safety - Cleco mPro400GCD-S Mode D'emploi

1

Notes on this Description

The information contained within this document is intended
fro all individuals responsible for connecting and installing
the controller.
mPro400GCD-S, mPro400GCD-SH
Software instructions are provided in separate program-
ming manuals based upon the version installed.
The original language of this document is German.
Minimum Software Requirements
No. Description
S168813 Standard Controller Software
S168677 mProRemote – Interface software between an
external computer and controller
Additional Document References
No. Document type
P1730E Reference Handbook
Fastening Sequences
P2279SB Systemhandbook NeoTek
P2280PM Programming Manual
mPro400GCD Standard SW
P3309C EC Declaration of Conformity
mPro400GCD-S
Important Symbols
Italic Identifies menu options), input fields, control
boxes, options fields or dropdown menus.
> Denotes the selection of a menu option from
a menu, e.g. File > Print
<...> Denotes switches, pushbuttons or keys of an
external keyboard, e.g. <F5>
Courier Denotes filenames and paths, e.g.
setup.exe
• Denotes lists, level 1
- Denotes lists, level 2
a) Denotes options
b)
→ Denotes results
1. (...) Denotes action steps in sequence
2. (...)
 Denotes a single action step
Sales & Cleco Production Tools – Sales & Service
Service Centers, see last page.
Centers
Apex Tool Group
2

Safety

2.1 General Requirements
 Only operate the controller after reading and fully
understanding this document. Failure to follow the
directions and safety instructions could result in elec-
tric shocks, burns and/or serious injuries.
 Keep this document in a safe place for future refer-
ence! These safety instructions must be accessible all
personnel programming, operating or repairing the
controller.
2.2 Intended Use
The controller is a part of the Cleco Production Tools Tight-
ening System and is intended exclusively for industrial use
in fastening processes. Only use the controller under the
following conditions:
• In accordance with the components listed in the EC
Declaration of Conformity.
• Identified environmental conditions; see relevant docu-
mentation.
• Appropriate supply voltage; reference respective docu-
mentation.
• In EMC Limit Class A (electromagnetic immunity for
industrial areas). For the currently observed EMC
standards, see the EC Declaration of Conformity.
2.3 Predictable Misuse
Do not use the controller:
• In potentially explosive areas.
• In damp locations or outdoors.
• In combination with cutting tools (drills, milling cutters,
grinders...).
• In non-industrial applications (eg residential area).
• For fastening applications not mentioned in the decla-
ration of conformity.
• If safety devices are being over-written.
2.4 Operator Training
The tightening system may only be put into operation,
adjusted and tested by qualified and trained personnel.
Personnel must be instructed by qualified employees of
Apex Tool Group.
The controller has been preset by Apex Tool Group.
Adjustmenty of the controller to accommodate special
requirements may only be carried out by a qualified per-
1)
son .
Additional information are available in the Programming
Manual.
1.) Due to their training, knowledge, experience and understand-
ing of the circumstances involved in this kind of work, suitably qual-
ified personnel are able to identify potential hazards and to initiate
appropriate safety measures. Qualified personnel are obliged to
comply with regulations.
P2349HW | 2019-08
1
EN
5