Installation; Right Place For Installation; Attaching The Plastic Wedges - Smeg FQ55FNDF Notice D'utilisation

Masquer les pouces Voir aussi pour FQ55FNDF:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 101
3

Installation

3.1. Right place for installation

Contact the Authorized Service for the product's
installation. To ready the product for installation,
see the information in the user guide and make
sure the electric and water utilities are as required.
If not, call an electrician and plumber to arrange
the utilities as necessary.
B
WARNING:
no responsibility for any damage caused
by the work carried out by unauthorized
persons.
B
WARNING:
must be unplugged during installation.
Failure to do so may result in death or
serious injuries!
A
WARNING
: If the door span is too narrow
for the product to pass, remove the door
and turn the product sideways; if this does
not work, contact the authorized service.
vibration.
heater, stove and similar sources of heat and at
least 5 cm away from electric ovens.
keep in damp environments.
function efficiently. If the product will be placed
in an alcove, remember to leave at least 5 cm
distance between the product and the ceiling
and the walls.
temperatures below -5°C.
The manufacturer assumes
The product's power cable

3.2. Attaching the plastic wedges

Use the plastic wedges provided with the product
to provide sufficient space for air circulation
between the product and the wall.
1. To attach the wedges, remove the screws on the
product and use the screws provided with the wedges.
2. Attach 2 plastic wedges on the ventilation cover as
shown in the figure.
8 / 31 EN
Refrigerator / User Manual

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Fq55fxdfFq55fxe1Fq55fx1Fq55fx2peFq55fn2pe

Table des Matières