Sp Dly Time (Speaker Delay Time); Range (Dynamic Range); R Balance (Balance Of The Front Left And Right Speakers); Hp Tone Ctrl (Headphone Tone Control) - Yamaha AVX-S80 Mode D'emploi

SET MENU
3 SP DLY TIME (speaker delay
time)
Use this feature to adjust the delay of the center channel
sounds. This feature works when there is sound output
from the center speaker, with a source like Dolby Digital
or DTS, etc. Ideally, the center speaker should be the
same distance from the main listening position as the left
and right speakers.
However, in most home situations, the center speaker is
placed in line with the front speakers. By delaying the
sound from the center speaker, the apparent distance from
the center speaker to the main listening position can be
adjusted to make it seem the same as the distance
between the front left and right speaker to the listening
position. Adjusting the delay time for the center speaker
is especially important for giving depth to the dialogue.
Control range:
CENTER ............. 0 to 5 ms
Initial setting:
CENTER ............. 0 ms
Press j / i to increase or decrease the delay
of the center channel sounds.
L
RL
y
• Increasing the delay by 1 ms simulates moving the speakers
about 30 cm (one foot) farther away from the listening position.
38
E8-S80-35-42(5.29)a
Center speaker image
C
C R
RR
38
4 D. RANGE (dynamic range)
Use this feature to adjust the dynamic range. This setting
is effective only when this system is decoding Dolby
Digital signals.
The dynamic range can be adjusted for speaker listening
and headphone listening independently.
Choices: MAX, STD (standard), MIN (minimum)
MAX
Select the "MAX" for feature films.
STD
Select the "STD" for general use.
MIN
Select the "MIN" for listening to sources at low volume
levels.
1
Press d/u to select "SP D.R" (for speaker
listening) or "HP D.R" (for headphone
listening).
2
Press j / i to adjust the dynamic range.
Note
• Some types of the Dolby Digital software do not support
"MIN" for the dynamic range. If "MIN" is selected to play this
type of software, the volume may be extremely lowered fall
greatly, sharply. If this happens, select "MAX" or "STD".
5 L/R BALANCE (balance of the
front left and right speakers)
Use this feature to adjust the balance of the output level
from the front left and right speakers.
Control range: 20 steps each for L/R
Initial setting: 0 dB for L/R
Press i to decrease the output level for the
front left speaker. Press j for the front right
speaker.
6 HP TONE CTRL (headphone tone
control)
Use this feature to adjust the level of the bass and treble
when you use your headphones.
Control range (dB):
BASS ................... –6 to +3
TRBL (treble) ..... –6 to +3
Initial setting:
BASS ................... 0 dB
TRBL .................. 0 dB
Press i to increase the level of the bass and treble, and
press j to decrease the level.
02.6.29, 4:34 AM