ABB CP-A RU Instructions De Montage Et De Mise En Service page 16

Technical data - Redundancy unit CP-A RU
Data at T a = 25 o C, unless otherwise indicated
Type
Input (+, -, +, -)
Rated input voltage U in
Input voltage range per channel
Rated input current per channel
Max. input current per channel
Transient overvoltage protection
Output (L+, L+, L-, L-)
Rated output voltage U out
Voltage drop
Rated output current I out
Output ratings per channel
Derating
Peak output current
Resistance to reverse feed
General data
Mounting
Mounting position
Minimum distance to other units, horizontal/vertical
Degree of protection
Material of enclosure
Protection class ( EN 61140)
Electrical connection
Wire size fine-strand with wire end ferrule
fine-strand without wire end ferrule
Stripping length
Tightening torque
Environmental data
Ambient temperature range
Damp heat (IEC/EN 60068-2-3)
Climatic class (IEC/EN 60721)
Isolation data
Insulation voltage
Pollution degree (EN 50178)
1) incl. lateral screw
2) This device is designed for connection to a safety extra-low voltage source. If no safety extra-low voltage is used at the input side, the lateral screw can be
used for grounding of the enclosure (protection class I).
3) According to UL this is the surrounding air temperature
When used use in combination with other power supplies than modules ABB series CP-S and CP-C, each input circuitry
shall be provided with overcurrent protection, Circuit breaker - Listed (DIVQ) Type S201 DC-K 6, manufactured by ABB
STOTZ-KONTAKT GmbH. Rated 60 Vdc, 6A
at T a = 60 °C
at T a = 70 °C
60 °C < T a < 70 °C
housing / terminals
housing shell / cover
rigid
3)
operation
storage
input / output / housing
CP-A RU
24 V DC
10-28 V DC
1-20 A
30 A for 300 s
yes
24 V DC
typ. 0.6 V, max. 0.9 V
1-40 A
10-28 V DC / 40 A
10-28 V DC / 30 A
2.5 % per Kelvin temperature increase
60 A for 300 s
< 40 V
DIN rail (TH 35-15 or TH 35-7.5 acc. to IEC/EN 60715),
snap-on mounting without any tool
horizontal
10 mm / 50 mm (0.39 in / 1.97 in)
IP20 / IP20
aluminium / zinc-coated sheet steel
III
2.5-10 mm
0.5-10 mm
0.5-16 mm
12 mm (0.47 in)
1.2-1.5 Nm
-25...+70 °C (-13...+158 °F)
-40...+85 °C (-40...+185 °F)
93 % at +40 °C, no condensation
3K3
500 V AC (routine test)
CP-A RU
in combination with CP-A CM
13-28 V DC
13-28 V DC / 40 A
13-28 V DC / 30 A
2)
2
(14-8 AWG)
2 (20-8 AWG)
2
(20-6 AWG)
2
16