Pur Line MISTY 10 Manuel D'utilisation page 14

Plug the power cord to connect the power supply, and then press the according button as needed.
1. ON/Speed Selection: Turn the knob clockwise to level "1" to start the fan and turn the knob again to
select the wind speed.
2. Wind Direction Selection: Select "1" by pressing the button "Swing" to enable the wind direction to
swing by left and right automatically and select "0" to stop the swing.
3. Elevation and Depression Angle Adjustment: Simply by touching the grill to adjust the elevation or
depression angle of the fan.
4. Humidifier: Mist switch and volume control. Turn from the right to left side to increase the mist
volume. A red indicator means not enough water and a blue one means it is working properly.
1. Remove water tank.
CLEANING AND MAINTENANCE
· Unplug the unit before cleaning.
·Any greasy dirt on the fan and fan blade should be cleaned with clean and mild detergent and soft
cloth.
· First, disassemble the fan (diagram 2).
· Clean the greasy dirt on the fan so as not to change the colour or cause damages:
- Clean with detergent and soft cloth.
- Avoid flushing with water directly.
- Avoid cleaning with thinner, toluene, acids, kerosene, essential oils, chemistry cloth so as not to
change the colour or cause damages.
· After cleaning, pack them in order and keep it in the dry place.
·
Cleaning of water tank (once a week)
If there is dirt in the water tank, clean it with detergent and flush it with clean water.
Notes
:
1) Do not touch the transducer with sharp tools, only clean with soft wet cloth.
2) Don't use the cloth with chemical solvents gasoline kerosene polishing powder to wipe the fan
appearance.
3) Avoid the water going into the appliance, it can cause malfunction.
4) Keep the appliance clean.
When the unit is not used for a long time, clean it and put it in the packaging and keep it in the dry place.
EN
2. Remove water tank cover.
12
3. Add water.