Pur Line MISTY 10 Manuel D'utilisation page 12

SPECIFICATIONS
Model: MISTY 10
Power: 200 W
Mist volume: <580 ml/h
COMPONENTS
Before installation, please check that all parts have been supplied
1. Mist Nozzle
2. Front grill
3. Grill fastener
4. Blade
5. Rear grille
6. Motor unit
7. Upper pedestal column
8. Lower pedestal column
9. Base cover
10. Water tank
11. Humidifier
12. Base
13. Mist volume control
14. Mist guide tube
ASSEMBLY
1
Power
supply
cable
1. Put upside down the base of the humidifier and remove the screw that fixes the column. Then place
the column through the base and align the tapping hole of the column and the position hole in the base,
and fix them with the screw. Finally, put the terminal of the motor unit through the column.
2. Fix the counterweight-plate in the base and then use the four meson screws
(M5 ×30) to fix the water level hole and the position hole in the base.
3. Insert the cable from the motor unit through the base cover. Connect the 2 columns by aligning the 2
fixing holes, and then tighten them with the screws (4x10).
4. Loosen the screw of the motor unit and then insert the motor unit terminal into the conncection
Voltage:
Water tank
Class:
2
Hole for water
level control
Power supply
cable
EN
~
220 - 240 V
6 L
II
3 4
Power supply
cable
10
Frequency: 50Hz
Size: 58x45x128 cm
Weight: 10.8 kg
Motor terminal
Column terminal
5
Mist nozzle