Comfee CP05S3WBA1RCM Guide De L'utilisateur page 15

Installation
NOTE: Once the Exhaust Hose assembly and Adjustable Window Slider are prepared, choose from one of
the following two installation methods.
Type 1: Hung Window or Sliding Window Installation(For some models)
Foam seal B
(Adhesive type-shorter)
Foam seal A
(Adhesive type)
1. Cut the adhesive foam seal A and B strips to the proper lengths, and attach them to the window sash
and frame as shown.
Window slider
Window
B(if required)
slider A
2. Insert the window slider assembly into the window opening.
Foam seal C
(Non-adhesive type)
3. Cut the non-adhesive foam seal C strip to match the width(or height) of the window. Insert the seal
between the glass and the window frame to prevent air and insects from getting into the room.
Security Bracket
2 Screws
4. If desired, install the security bracket with 2 screws as shown.
Or
Foam seal A
(Adhesive type)
Window slider B
(if required)
Or
Window slider A
Foam seal C
(Non-adhesive type)
Or
Security
Bracket
Or
2 Screws
Foam seal B
(Adhesive type-shorter)
15