Pur Line FRESH AIR 40 Manuel D'utilisation page 12

CONTROL PANEL
POWER: Press to turn on / off. The air quality indicator lamp will light up. It will run in AUTO mode.
AUTO: Press the Auto button. The Auto indicator will glow and the unit automatically adjust the air flow
depending on the indoor air quality. The Air Quality indicator lamp will glow to the corresponding level of air
quality.
SLEEP: Press the Sleep button. The sleep indicator will light and the air purifier will run in min speed.
AIR FLOW: Press Air Flow button, the corresponding speed indicator will light and the air purifier will run in
selected speed. You can change the speed by pressing the airflow selected button.
TIMER: Press the Timer button, you can set the specific time to automatically switch off the air purifier. The set
time will be indicated on the display.
LIGHT: Press the Light button to switch on/off the air quality light and air flow indicator. This function can be
used during night, when you do not want any light to disturb your sleep.
ION: Press Ions button. The indicator will light while anion generator releasing anions.
UV: Press the UV button, the indicator will light while the UV LED is turned on.
SLEEP (Night Light Function): the Air Quality indicator lamp will glow yellow and do not change with air quality.
PM2.5 Indicator function: After startup, the PM2.5 indicator will glow twinkle, 30 second later, it will show the
indicator of PM2.5 detected by sensor.
Notice: This function cannot be used as professional instrument.
FILTERS: Press this button when startup, the button lamp light, and the display will show the Residual life of
filters "%". 3 seconds later, it will turn back.
When the filters need to be changed, the button lamp glow twinkle. After replace filters, press this button for
5 seconds to reset.
Light Color Blue Yellow
Air quality Good Moderate
Red
Bad
10