Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

To TV Set and Aerial
Basic connection:
Ensure that the power switches of this unit and other equipment to be connected, are turned
off before commencing connection
Read attentively the instructions before connecting other equipments
Ensure that you observe the color-coding when connecting audio and video cords
Please connect the unit with TV by only one kind of video output format, and setup a suitable
output mode (including signal mode and signal code type), otherwise there will be image
distortion.
REMARKS:
User can choose any proper connection format according to the jacks of the TV set.
CONNECTING TO TV SET AND AERIAL
1.
Connect the Aerial to the antenna Input
2.
Connect the SCART cable to the TV set
3.
Connect the SCART cable to SCART TV port of the DVB-T receiver
4.
Plug the AC power cord cable to the wall outlet
5.
Switch on the TV set and the DVB-T receiver
6.
Select the SCART input by the TV set
7.
Change if necessary the TV output settings by the DVB-T receiver. Choose the video output to
RGB and pay attention to the aspect ratio.
Notes:
By using the loop through connector you can connect for example a second HRT 5000.
You can plug passive or active indoor antenna to the DVB-T receiver.
The best reception condition you can get by using a Aerial antenna.

Connection

HRT 5000
13

Publicité

Table des Matières
loading

Table des Matières