Safety Information - Xoro HRT 5000 Mode D'emploi

User Manual
1. All the safety and operating instructions should be read before the product is operated.
2. Retain Instructions - The safety and operating instructions should be retained for future
reference.
3. All warnings on the product and in the operating instructions should be adhered to.
4. All operating and use instructions should be followed.
Antenna
The device can be connected to an antenna.
1. Unplug the power cord cable from the mains outlet before connecting or disconnecting the
DVB-T to/from the antenna, otherwise both might be damaged.
2. If an outside antenna or cable system is connected to the product, be sure the antenna or
cable system is grounded so as to provide some protection against voltage surges and built-
up static charges.
However, this is no guarantee that these problems can never occur. If these problems occur to you,
please try the following:
•
Position or align the receiving antenna is different.
•
Increase the separation between the equipment and faulty equipment.
•
Plug the power cord of the DVB-T receiver in a different outlet than the faulty device.
•
Please contact the dealer or a radio / TV technician.
If you see by the information Signal strength and Signal quality some low values, you can try to find
another antenna position to increases the reception quality. Visible indicators for a worst reception of
the DVB-T signals is for example the a freeze picture or the message "No Signal".
The reception quality depends for example on the kind of the antenna. Three different kind of antenna
are available, the passive and active indoor aerial and the roof antenna. Realign your indoor aerial in
this way, that you get the best reception as possible. Helpfully it to know in which direction are the
public antenna power and than you can adjust the antenna to this direction.
If a passive indoor aerial can not receive the DVB-T signal strong enough, please try an active indoor
aerial. The best reception results are by the roof antenna possible.
4

SAFETY INFORMATION

The lightning flash with an arrowhead symbol within an equilateral triangle is intended
to alert the user of the presence of uninsulated "dangerous voltage" within the
product's enclosure that may be of sufficient magnitude to constitute a risk of electric
shock to persons.
The exclamation point within an equilateral triangle is intended to alert the user of the
presence of important operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS
SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1)THIS DEVICE MAY NOT
CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY
INTERFERENCE RECEIVED. INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
HRT 5000