Safety Instructions; Relating Specifically To; The Equipment - Meister EF600M Traduction Du Manuel D'utilisation Original

persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are danger-
ous in the hands of untrained users.
e Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any
other condition that may afect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by
poorly maintained power tools.
f Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to
bind and are easier to control.
g Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from those intended
could result in a hazardous situation.
5 Service
a Have your power tool serviced
by a qualified repair person using
only identical replacement parts.
This will ensure that the safety of the
power tool is maintained.
b To avoid hazards, damaged power
leads must be replaced by the
manufacturer or his customer service
representative.
6 – Safety instructions
relating specifically to

the equipment

• Wear protective goggles and gloves
and, if necessary, ear protectors and
34
breathing mask.
MW-5461060-Bedien-2005.indd 34 MW-5461060-Bedien-2005.indd 34
• Always fix the tool down securely on
an even surface, if necessary, using
clamping fixtures.
• Never feed the work-piece to be
ma c hined to the tool by hand! Use for
this either a small piece of wood or the
plas t ic guide block supplied with the
tool.
• Never use cracked or segmented saw
blades.
• Before starting work always check the
water level in the cooling water reservoir
and, if necessary, fill or top it up with
water. If cutting for longer periods,
check the water level from time to time.
• Before starting work allow the cutting
wheel to reach the required speed.
• After switching off wait for the cutting
wheel to stop rotating. NEVER TRY
TO BRAKE IT!
• Always ensure that the protective
hood (1) is fitted and can move freely.
• Replace faulty protective hoods
immediately.
• Do not stand in a line with the cutting
blade in front of the machine. Always
stand aside of the saw blade. This
protects your bodyagainst possible
kickback.
• Keep hands, fingers and arms away
from the rotating cutting blade.
• Determine the cause of the blockage
and eliminate it.
Safety marking
The symbols on the housing mean the
following:
13.05.20 11:02 13.05.20 11:02