Components; Correct Use - Meister EF600M Traduction Du Manuel D'utilisation Original

Safety measures must be taken in
order to protect the operator. As a
result, the evaluation of the influence
must be made whilst taking account
of the actual conditions of use. (All
parts of the operating cycle must be
taken into account for this purpose.
This also includes times in which
the tool is switched of and times in
which it is switched on, but is running
without load.)
3 – Components
1 Protective hood
2 Cutting disc
3 Scale for parallel cuts
4 Work bench
5 Marking for mitre cutting
6 Fixing screws for mitre setting
7 Water reservoir
8 ON/OFF switch
9 Fixing screws for parallel stop
10 Parallel stop
11 Angle stop
12 Fixing screw for protective hood
13 Adjustment key
14 Plastic cover hood
4 – Correct use
Cutting of ceramic, stoneware, natural
stone and thin concrete slabs up to a
maximum thickness of 34 mm. Use the
tool, cutters and accessories for the
specified applications only. Follow the
manufacturer's instructions. All other
applications are expressly excluded.
The machine is intended only for use in
the household.
This device is not designed to be used
by people (including children) with
limited physical, sensory or mental
capacities or those without experience
MW-5461060-Bedien-2005.indd 31 MW-5461060-Bedien-2005.indd 31
and/or knowledge. Children should be
supervised to ensure that they do not
play with the device.
Improper use of the product
All applications carried out with
the device that are not listed in the
"Correct use" chapter will be considered
improper use.
Uses for which the tool is not designed
may cause risks and injury. Do not
use accessories that are not intended
specifically for this electrical tool.
Just because you can affix an accessory
to your electrical tool, there is no
guarantee it is safe to use.
The permitted revolutions of the tool
insert must be at least as high as the
highest value specified on the electrical
tool. Accessories that turn faster than is
permitted may break and fly away.
The external diameter and thickness
of the tool insert must match the
dimensions of your electrical tool.
Incorrectly measured tool inserts cannot
be properly protected or checked.
Cutting discs or other accessories must
fit precisely onto the sanding spindle of
your electrical tool. Tool inserts that do
not fit precisely to the sanding spindle
of the electrical tool will rotate unevenly,
vibrate very heavily and may lead to a
loss of control.
There is a risk of injury. The user of
the device is liable for all property and
personal damages occurring as the
result of incorrect use.
If other components or non-original
components are used with the machine,
the manufacturer guarantee is voided.
31
13.05.20 11:02 13.05.20 11:02