Installation And Setting - Meister EF600M Traduction Du Manuel D'utilisation Original

Do not dispose of with the
household waste!
Important! Observe the
operating instructions!
Wear goggles.
Wear a dust protection mask.
Wear ear defenders.
Protection class I
Voluntary "geprüfte Sicherheit"
seal of quality (tested safety)
CE mark (conformity with
European safety standards)
Machine weight
Max. cutting depth
BJ Year of construction
SN: Serial number
SN: XXXXX T he first two underlined
numbers give the month of
manufacture.
7 – Installation and setting
Selecting and replacing the diamond
cutting wheel
WARNING! Pull out power plug.
MW-5461060-Bedien-2005.indd 35 MW-5461060-Bedien-2005.indd 35
Remove the water reservoir (7) and the
plastic cover hood (14) (Figure 2). Undo the
outer hexagonal screw. Remove the flange
and replace the diamond cutting disc (2)
(Fig. 3). Reassemble in the reverse order.
WARNING! Make sure that the
arrow showing the direction of
rotation on the new cutting wheel
points in the same direction as the
arrow on the protective hood on the
work plate.
IMPORTANT! Use only MPA­tested
diamond cutting discs.
Check the ring cutter
for hairline cracks
and deformation
before using, and, if
necessary, replace
the disc. Always use
suitable diamond discs for wet
cutting. The choice of disc depends
on the material to be cut, so always
follow the maker's instructions.
Parallel stop
The parallel stop (10) enables cuts to
be made lengthways along the work-
piece. For this simply set at the desired
distance from the cutting disc, using the
scale for parallel cuts (3).
Angle stop
For this secure the parallel stop (10) on
the other side of the cutting wheel and
set the angle stop (11) on the rail.
Mitre setting
The adjustable work plate
enables mitred cuts at angles
of up to 45 o to be made. To
obtain the desired mitre undo the two
35
13.05.20 11:02 13.05.20 11:02