Installation And Setting - Meister MMF1700-1 Traduction Du Manuel D'utilisation Original

5459200-Mauernutfr_man 22.06.17 07:47 Seite 55
may result in hazardous laser beam
related effects.
• The power tool is supplied with
warning signs. These must be applied
in accordance with Figure 9
• Do not look into the laser beam. Looking
into the laser outlet from a distance of
100 mm with optical instruments (e.g.
magnifying glass or microscope) may
cause a risk of damage to the eyes.
• Never point the laser beam towards
people or animals.
• Never use the laser beam on very
reflective materials. There is a risk
posed by the reflected light.
• Have repairs to the laser projector
carried out by specialists only.
• Do not introduce hard objects into the
laser optic (15).
• Clean the laser optic with a soft, dry
brush.
Do not dispose of with
domestic waste!
Important! Observe
operating instructions!
„Tested Safety" voluntary
quality mark
Housing is double insulated
CE Mark (conformity to
European safety standards)
Caution laser beam! Do not
look into the beam!
Wear goggles.
Wear a dust-protection mask
Wear ear defenders.
Always work with a dust
collection system
connected!
7 – Installation and setting
CAUTION! Disconnect the power
cable before all assembling and
setting work!
Changing the cutting discs, setting
the cutting width
CAUTION! Diamond cutting discs
may become very hot when
being used. Do not touch cutting
discs until they have cooled down!
• Remove the setting screw (4) for the
depth stop (5). Loosen the screws
marked on Figure 2 using the
hexagonal wrench (24). Remove the
protective hood.
Press the spindle lock (13) and hold to
ensure that the cutting wheel does not
continue to rotate (Figure 3).
Use the face spanner (22) to undo the
clamping nut (6) and turn to the right (!)
to undo and remove. The cutting disc
and spacers can now be removed.
Changing the cutting dics
Pull the cutting discs (7), spacers (14a, b)
off over the sleeve (18) (Figure 7).
55