Components; Correct Use - Meister MMF1700-1 Traduction Du Manuel D'utilisation Original

5459200-Mauernutfr_man 22.06.17 07:47 Seite 48
Hand/arm vibrations
a : 5,319 m/s
hv
Measuring inaccuracy K: 1,5 m/s
Noise/vibration information
Measured values determined in
accordance with EN 60745-1,
EN 60745-2-22.
The specified vibration emission value
was measured in accordance with a
normed test procedure and can be used
in order to compare one electrical tool
with another.
The specified vibration emission value
can also be used for an introductory
evaluation of the influence.
CAUTION! The vibration
emission value may fluctuate
from the specified value during use of
the power tool. These fluctuations will
depend on the way in which the
power tool is used.
Safety measures must be taken in
order to protect the operator. As a
result, the evaluation of the influence
must be made whilst taking account
of the actual conditions of use. (All
parts of the operating cycle must be
taken into account for this purpose.
This also includes times in which the
power tool is switched off and times
in which it is switched on, but is
running without load.)
CAUTION! A certain amount of
noise is unavoidable when using
this device. Ensure you carry out
noise-intensive work during permitted
times. Maintain the quiet periods and
limit your work to the absolute
minimum.
48
2
2
CAUTION! The effects of noise
may cause damage to the
hearing. Only ever work with suitable
ear defenders. Anybody else in the
vicinity should thus also wear ear
defenders.
3 – Components
1 Additional handle
2 Laser marking aid
3 Protective hood
4 Setting screw for depth stop
5 Depth stop
6 Tensioning flange
7 Cutting wheel
8 Extraction duct
9 Vacuum support
10 Handle
11 On/Off switch
11a Safety switch
12 Guide roller
13 Spindle lock
14a Spacer 15,5 mm
14b Spacer 10 mm
15 Laser optic
16 Spindle
17 Tensioning flange
18 Sleeve
19 Laser On/Off switch
20 Battery compartment lid
21 2 x batteries
22 Face spanner
23 Flat chisel
24 Hexagonal wrench
25 Adapter for external dust extractor
4 – Correct use
The wall chaser is used to cut pipe and
cable ducts in brickwork and cement.
This unit is only designed for private use.
This unit may not be used by people
(including children) with reduced
physical, sensory or mental capacities,