Publicité
Les langues disponibles
Les langues disponibles
SF 0440
• Turn the fan on and select the desired running speed with the speed control (0 – off; 1 – low; 2 – medium;
3 – high) switch conveniently and safely located at the front of the fan below the front grill.
• To adjust the fan's height, loosen the height adjustment knob by unscrewing counter clockwise only a few
turns. Pull upward on the chrome portion of the base assembly while holding the lower portion firmly to
raise the height, or push down on the chrome portion to lower. Retighten the height adjustment knob,
being careful not to overtighten.
• To adjust the normal upward or downward tilt of the fan head, loosen the tilt knob on the side of the
motor assembly and carefully lift or lower the head angle while holding the rear grill handle. Do not force
the read. Re-tighten the tilt knob when the desired angle is found.
• The fan's direction can be adjusted relative to the base by loosening the thumb screw at the bottom of the
motor, assembly, and rotating the fan head.
• To set the fan into oscillation, depress the oscillation knob on the top of the motor assembly. The fan
head will pivot side to side and up and down. For stationary operation, pull up on the oscillation knob.
CARE, CLEANING & STORAGE
• The fan blade and grill set should be cleaned regularly for most efficient operation. Unplug the fan, then
reserve the assembly procedure to remove those parts from the motor assembly before cleaning. Wipe
with a damp cloth then towel dry.
• Never immerse any fan components in water. Wipe the fan only with a dry or slightly moist cloth, then
immediately towel dry.
• Always store the fan in a cool dry location.
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted municipal
waste stream. Old appliances must be collected separately in order to optimize the recovery and
recycling of the materials they contain, and reduce the impact on human health and the
environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when you dispose
of the appliance, it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the correct disposal of
their old appliance.
DECLARATION OF CONFORMITY:
This device complies with the requirements of the Low Voltage Directive 2006/95/EC and the requirements
of the EMC directive 2004/108/EC.
9
Publicité
