Publicité
Les langues disponibles
Les langues disponibles
V 4.1
2.
Align the holes of the handlebar with the mounting bracket and secure
each with a spring washer, flat washer and an M10x20 bolt. Fasten each
handlebar support onto the engine deck with a spring washer, flat washer
and an M8x25 hex bolt (Fig. 3).
3.
Position the bottom panel inside the mounting bracket. Align the holes with
the mounting bracket. Insert a long pin through holes and secure each side
with a flat washer and cotter pin (Fig. 4).
OPERATION
Consult the engine manual for the correct procedure to start and stop
the engine.
1.
Start the engine. After the engine warms up, adjust the throttle control (B)
to increase the engine speed.
2.
Choose a gear with the gear selection lever (G) and slowly squeeze the
clutch control lever (D) to start moving. If the gear does not engage
straight away, slowly release the clutch lever and try again.
3.
The power wheelbarrow has steering levers on the handlebars (C and E).
To turn right, squeeze the right steering lever to slow or stop the track on
that side. The power wheelbarrow will then turn in that direction.
The steering sensitivity increases in proportion to the speed of the
machine. Light pressure on the lever is all that is needed to turn an empty
machine. More pressure is required when the machine is loaded.
Visit www.princessauto.com for more information
660 lb Power Wheelbarrow
Fig. 2
Fig. 3
8724981
Fig. 4
7
Publicité
