Publicité
Les langues disponibles
Les langues disponibles
8724981
TIGHTEN TRACKS
WARNING! An overtight track will impair the brake's effectiveness. Test and
adjust the brakes after tightening the track. Replace the track if any
adjustment affects the brakes normal function.
A loose track can slip off the driving wheel. This can cause a hazardous situation or
damage to the equipment. Check the track's tightness on a regular basis.
1.
Set the machine on a flat surface of
asphalt, stone or pavement. Compact
ground is also acceptable.
2.
Lift the machine and set it on blocks or
supports rated for the weight of the machine,
so that the tracks are approximately 4 in.
(100 mm) off the ground.
3.
Measure the track midline vs. the horizontal
line. The reading must not be more than
10-15 mm. If the distance is greater,
proceed as follows (Fig. 5).
a.
Tip the dump box and set it on blocks
or supports capable of holding the weight of the box.
b.
Loosen locknut A.
c.
Tighten bolt B until the correct tightness is restored to the track.
d.
Secure bolt B by retightening locknut A to secure the bolt in place.
e.
Return the dump box to its original position.
NOTICE! Replace the track if the guide wheel axle (#81) is fully extended
forward and the track is still too loose.
REPLACING A TRACK
WARNING! Keep hands away from the track and wheels when under power to
avoid a crushing injury.
Check the condition of the tracks periodically. Replace a track that is cracked
or frayed.
1.
Set the machine on a flat surface of asphalt, stone or pavement. Compact
ground is also acceptable.
10
660 lb Power Wheelbarrow
For technical questions call 1-800-665-8685
V 4.1
Fig. 5
Publicité
