Publicité
Les langues disponibles
Les langues disponibles
V 4.1
2.
Lift the machine and set it on jack stands or supports rated for the weight
of the machine. The tracks should be 4 in. (100 mm) off the ground.
3.
Loosen locknut A and bolt B (Fig. 5) fully to release tension from the track.
4.
Pull the track off the toothed drive wheel at the rear by hand if possible. An
alternative is to use a wood block and crowbar to remove the track.
a.
Start the engine and shift the power wheelbarrow into reverse.
b.
Place a long wood block against the track and drive wheel. The wood
block will lift the track off the drive wheel as it rotates. Place the
power wheelbarrow into neutral gear as soon as the track has lifted.
c.
Pull the track towards the side with the crowbar until the track slides
off the wheel. Remove the wood block.
WARNING! Do this carefully to avoid tipping the machine over. The machine
is heavy and can cause a crushing injury.
d.
Shut the engine OFF.
e.
Pull the track off the other wheels.
5.
Place the new track so the teeth
are on either side of the front
wheel. Position the track so it
aligns with the other wheels.
6.
Place the track on the rear drive
wheel by hand if possible. Use a
crowbar to slip the track onto the
teeth of the drive wheel.
7.
Start the engine and place the
power wheelbarrow in reverse until the drive wheel's teeth slip into the
slotted holes of the track.
8.
Adjust the track tension as explained in the section Tighten Tracks.
ENGINE MAINTENANCE
Refer to the Engine Manual included in your unit for the information on engine
maintenance. Your engine manual provides detailed information and a
maintenance schedule for performing the tasks.
Visit www.princessauto.com for more information
660 lb Power Wheelbarrow
8724981
Fig. 6
11
Publicité
