Publicité
Les langues disponibles
Les langues disponibles
8724981
IDENTIFICATION KEY
A
Engine Switch
B
Throttle Control
C
Right Steering Lever
D
Clutch Control Lever
E
Left Steering Lever
F
Dump Box
G
Gear Selection Lever
H
Tipping Handle
I
Track
J
Gearbox
Engine Switch -The engine switch enables and disables the ignition system. The
engine switch must be in the ON position for the engine to run. Turning the
engine switch to the OFF position stops the engine.
Throttle Control - Controls engine speed. Set the power wheelbarrow's speed to
low (L), middle and high (H) speed.
Right Steering Lever - Operate the lever to turn right.
Clutch Control Lever- Squeeze the control lever to engage the clutch. Release
the lever to disengage clutch.
Left Steering Lever - Operate the lever to turn left.
Gear Selection Lever – Switch between forward and reverse.
Tipping Handle - Pull the tipping handle up to release the dump box's locking
device and raise the dump box. Pull the tipping handle down to its original position.
When the dump box is lowered, the locking mechanism locks the dump box. Lift
the dump without using the tipping handle to confirm it is locked in position.
ASSEMBLY & INSTALLATION
When this manual refers to a part number, it refers to the included Parts List.
1.
Mount the tipping handle onto the panel's right side. Align the holes and
fasten with two M8x35 hex bolts, four washers and two nuts (Fig. 2).
6
660 lb Power Wheelbarrow
For technical questions call 1-800-665-8685
V 4.1
Fig. 1
Publicité
