Inserting And Changing The Plates; Use - gourmetmaxx ST65 Mode D'emploi

EN

Inserting and changing the plates

ATTENTION!
■ Make sure that the device is not connected to a socket when inserting or changing
the plates.
■ Make sure that the device and the plates have cooled off completely before you take
the plates out of the device or exchange them with another pair of plates.
1. Select a pair of plates you would like to insert in the device, open the locking latch
and open the device.

Use

ATTENTION!
■ Hot surfaces! Only hold the device by the plastic handles during operation and
shortly after turning it off. We recommend you wear kitchen gloves when handling
the device.
■ Scalding hazard! Steam may be emitted from the device. Be careful when opening
or closing the device.
■ Never use the device with just one plate! Two plates must always be installed. If
only one plate is installed, the thermostat could malfunction as a result. The device
could overheat and short circuit resulting in damage to the device.
■ Make sure that you do not overfi ll the device! The device should generally be easy to
close. Do not forcefully attempt to close the device!
■ Be careful when fi lling the device with liquid waffl e batter! If your overfi ll the device,
the batter may run over the sides of the device.
20
2. Insert one of the plates in the device, by placing the catch-
es of the plate in the corresponding openings of the device
(see fi gure).
3. Then push the plate on the upper side into the device by
applying slight pressure until the latch on the plate audi-
bly lock into place. If you would like to take the plates out
of the device or change them, you must push the corre-
sponding latch towards the handle; the plate will be eject-
ed out of the device.
4. Repeat steps 2 and 3 for the second plate.