GE Advantium CSB923 Mode D'emploi page 11

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3 INSTALL BOTTOM TRIM
NOTE: If installing the Advantium 240 Oven with
an accessory storage drawer, the bottom trim is
not required. Proceed to Step 4.
• Align bottom trim tabs to slots in the bottom of the
oven.
• Secure the bottom trim to the bottom of the
oven using 3 brass screws provided.
1" = 2.5 cm; 1' = 0.3 m
31-2000356 Rev.0
Installation Instructions
4 INSTALL MOUNTING SCREWS
• Slide the oven the remaining way into the
opening so that the side flanges and control
panel are against the cabinet frame. Make sure
that the oven is centered in the opening.
• Open the door, place a turntable tray in the oven
and make sure that the tray in the unit is level.
• Drill pilot holes through the side flanges.
• Drive the color matched screws into the side
flanges. It is recommended that the screws
be hand tightened.
If installing oven with an accessory storage
drawer:
• Open the drawer.
• Drill pilot holes through the side flanges.
• Drive color match screws into the side flanges.
It is recommended that the screws be hand
tightened.
5 FINALIZE INSTALLATION
• Turn power on at the source. The interior light
should come on when the door is opened.
• Refer to Owner's Manual for operating
instructions.
11

Publicité

Chapitres

Table des Matières
loading

Table des Matières