Volvo Penta 21323189 Instructions De Montage page 3

English -
Introduction
This installation instruction covers parts or accessories manufactured or marketed by Volvo Penta and used in the
specified application and for the intended purpose recommended by Volvo Penta. Any use other than those
specified may give unpredictable results and result in equipment failure or personal injury.
Proper preparation is extremely helpful for efficient service work. A clean work area at the start of the job will
minimize tools and parts becoming misplaced. Obtain tools, instruments and parts needed for the job before work
is started. Interrupting a job to locate special tools or repair kits is a needless delay.
When following these instructions the installer must adhere to all U.S. Coast Guard Safety Regulations and ABYC
Recommendations and Standards, or other regional regulation that may be in effect.
Service Policy
Whether within or following the warranty period, Volvo Penta has a constant interest in our products.
It is Volvo Penta's policy to provide dealers with service knowledge so they can give professional service
demanded by today's consumer. Volvo Penta Service Schools, frequent mailing of Service Bulletins, Letters and
Promotions, Special Tools and these instructions represent Volvo Penta's efforts in giving consumers the best and
most prompt service possible. If a service question does not appear to be answered in these instructions, you are
invited to call or write to the Volvo Penta Service Department for additional help. Always be sure to give complete
information, including engine model and serial number.
Be sure you are familiar with Volvo Penta's Warranty. If you have any questions, call or write the Volvo Penta
Service Department. If other than genuine Volvo Penta parts and components are used, Volvo Penta may refuse
subsequent warranty claims involving that engine.
When a brand-name product or specific tool is specified, another item may be used. However, the substitute must
have equivalent characteristics, including type, strength, and material. It is your responsibility to determine if
incorrect substitution could result in product malfunction and personal injury to anyone. To avoid hazards,
equivalent products which are used must meet all U.S. Coast Guard Safety Regulations and ABYC standards.
References, Illustrations and Specifications
Volvo Penta reserves the right to make changes at anytime, without notice, to specifications, models, and
procedures. Also, the right to change any specifications or parts at any time without incurring any obligation to
equip same models manufactured prior to date of such change. All information, photographs, illustrations, and
specifications, contained in these instructions are based on the latest information available at the time of printing.
Photographs and illustrations used in this instruction may not depict actual models or equipment. The continuing
accuracy of this installation instruction cannot be guaranteed.
Use the general torque specification for all fasteners unless otherwise specified in the instructions.
Important Safety Notices
Carefully observe the safety alert symbols below for dangers, warnings, and cautions. They alert installers and
operators of possible dangers or important information contained in this manual.
Warnings alone do not eliminate hazards. They are no substitute for professional workmanship and proper
installation.
DANGER!
or serious injury.
WARNING! Failure to comply with a warning symbol may result in death
or serious injury.
CAUTION! Failure to comply with a caution symbol may result in injury.
NOTICE! Special attention should be used to prevent incorrect assembly or disas-
sembly. Failure to comply with a notice may result in equipment failure or damage.
7749431 VPA 12-2010
Failure to comply with a danger symbol will result in death
1