Skytec SUPER STROBE 153.347- 750W-DMX Mode D'emploi page 5

All manuals and user guides at all-guides.com
REPLACING THE FLASH-TUBE
CAUTION: Before replacing the flash-tube, unplug the device and let the lamp cool down.
(approx. 5 minutes)
1.Make sure the unit is not plugged into any
power outlet. Unscrew 4 screws and take down
the protective glass (figure 4).
2.Unscrew the screws on the PCB plate at both
sides and take the plate out of the casing (figure 5).
3. Press the tube-holder (the two steel plates inside
the super strobe), take the old flash-tube out of
the tube-holder. Then, place the new flash-tube
into the tube-holder (figure 6).
4. Connect the tube wires and trigger wire
with the PCB plate. Screw them tightly.
Note: The trigger wire is tiny, please do not
damage it when screw in (figure 7).
5. Place the PCB plate into the casing;
Place the protective glass. Screw tightly (figure 8).
- For the installation, you need one the right Xenon bulb for it.
- The flash tube has to be replaced when it is damaged or deformed due to the heat.
- A frequent cleaning of the device is recommended. Please use a moist, lint-free cloth.
Never use alcohol or solvents!
TECHNICAL SPECIFICATION
Type Nr.
Power supply
Power consumption
Max. ambient temperature
Max. housing temperature
Do not attempt to make any repairs yourself. This would invalid your warranty.
Do not make any changes to the unit. This would also invalid your warranty.
The warranty is not applicable in case of accidents or damages caused by inappropriate use or disrespect of the
warnings contained in this manual.
SkyTronic UK cannot be held responsible for personal injuries caused by a disrespect of the safety
recommendations and warnings. This is also applicable to all damages in whatever form.
153.347 153.345
230V AC, 50HZ
1700W 750W
45˚C 25˚C
130˚C 100˚C