Skytec SUPER STROBE 153.347- 750W-DMX Mode D'emploi page 3

All manuals and user guides at all-guides.com
For your own safety, please read this user manual carefully before initial start-up.
SAFETY INTRODUCTION
- Keep the manual for further reference.
- This device is a lighting effect for creating decorative effects. It is only allowed to be
operated with a voltage of 230V, 50Hz and was designed for indoor used only.
- During use, these lamps get very hot. Therefore the light effect must be placed at least 1m
away from inflammable materials such as curtains, books, etc. Make sure that the housing
cannot be touched by accident.
- Any installation, operation and maintenance of this device should be carried out by a
qualified person.
- If the device is damaged by transportation, do not use it and consult your dealer.
- Never let the power-cord come into contact with other cables. Handle the power-cord and all
connections with the mains with particular caution.
- Do not turn on the device for 5 minutes after switching off.
- The device is not a toy. Keep it away from children.
- Prior to the first use, have the unit checked by a qualified person.
- The unit contains voltage carrying parts. DO NOT open the light effect.
- Never plug or unplug the unit with wet hands.
- Disconnect the unit from the mains prior to replacing the fuse.
- If the plug or mains lead are damaged, they need to be repaired by a qualified technician.
- If the unit is damaged to an extent that you can see internal parts, do not plug the unit into a
mains outlet.
- Always unplug the unit during a thunderstorm or when it is not in use.
- If the unit has not been used for a longer period of time, condensation can occur inside
- When you unplug the unit from the mains always pull the plug, never the lead.
- The supplied bracket is the main fixing and must be used to solidly mount the light effect.
- In order to avoid accidents in public premises, the local legal requirements and safety
regulations/warnings must be fulfilled.
OPERATION INSTRUCTION
- Do not shake the device. Avoid brute force when installing or operating the device.
- The symbol determines the minimum distance from lighted objects. The minimum
distance between light-output and the illuminated surface must be more than 0.5m.
- When rigging, derigging or servicing the fixture, please make sure that the area below the
installation place is blocked.
- The maximum ambient temperature must never be exceeded 45°C.
INSTALLATION
CAUTION:
- The device must be installed out of reach of people.
- The installation must only be carried out by an authorized dealer.
RIGGING
- Before rigging, make sure that the installation area can hold a minimum point load of 10
times the weight of the device.
- The super strobe may cause severe injuries when crashing down! If you have doubts
concerning the safety of a possible installation, do NOT install the projector.
- When installing the device, make sure there is no highly-inflammable material within min.
0.5m.
- When rigging, the screws must be fixed tightly.
- The installation of this device must be approved by a skilled person once a year in the
course of an acceptance test.
GB