Skytec SUPER STROBE 153.347- 750W-DMX Mode D'emploi page 4

All manuals and user guides at all-guides.com
DMX CONNECTION
The two 3-pin connectors (as following: figures1-2) are for the DMX system. The device
needs two channels to control it.
ADDRESS SETTING
The following tables show the address setting on the fixtures (1-128).
(figure 3)
Procedure:
CAUTION:
The switch"#10" is for testing. During the address setting, "#10" must be turned "OFF".
1. Search the figure of your fixture.
2. Search the corresponding number horizontally among the address switch (#1-#5);
Search the corresponding number vertically among the address switch (#6-#9).
IMPORTANT: The number "0" indicates the switch is turned "OFF". The number "1"
indicates the switch is turned "ON'.
EXAMPLE: To search the 50th fixture address.
1. Find out the figure"50" in the table "ADDRESS SETTING ";
2. Search the number among the switches (#1-#5) horizontally; they are 1, 0, 1, 0, 0;
3. Search the number among the switches (#6-#9) vertically; they are 0, 1, 1, 0;
4. The way to set the 50th fixture address is : TURN ON: 1, 3, 7, 8; TURN OFF: 2,
4, 5, 6,9.
CAUTION: Before connecting the strobe with the controller, all channels have to be set to
minimum position.
DMX channel 1= Speed
2= Intensity