Wetrok iMatic XR85 Mode D'emploi page 38

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
Use only original Wetrok accessories and consumables. To achieve optimum cleaning and service life of the machine we recommend
using Wetrok chemical products. No guarantee or liability will be accepted for damage or consequential damage resulting from the use
of other products.
During cleaning operation, the machine must only be used on inclines or declines of less than 2%.
The machine support stability is only ensured up to a 15% slope.
Do not move the machine on slopes of more than 8%.
Do not reverse the machine down slopes of more than 8%.
Do not turn or drive the machine across slopes of more than 2%.
Safety regulations relating to operation and maintenance are set out in the relevant chapters, and adherence to these regulations
is mandatory.
Damage and consequential damage arising from non-observance of these instructions through improper treatment or using the
appliance for purposes other than those intended will result in claims under the guarantee and liability becoming void.
Do not overfill the tank. Water running down can damage the machine.
Do not let pumps run without cleaning fluid (can be discerned by a rattling noise). This can result in the pumps being destroyed by overheating.
On the other hand a pulsating noise where water levels are set low is normal and depends on the function.
Before opening the water filter, the machine must be completely drained. Catch any remaining water that runs out.
Ensure that no water is splashed inside the machine.
Do not remove safety lid of control system!
Suction of sharp or long solid objects can result in injury or the machine clogging, and must be avoided.
Only use original charging cable.
1.1 Improper use
Any type of use of the machine not described in "Proper use" or not contractually agreed is prohibited.
The following is especially prohibited:
Use as a towing vehicle, transporter or toy.
Cleaning operation up or down slopes of more than 2%
Driving or parking on slopes of more than 8%.
Reversing down slopes of more than 8%.
Turning or driving across slopes of more than 2%.
Dry cleaning, removal of hazardous dust.
Suction of inflammable, toxic, corrosive, irritant substances or substances hazardous to health.
Cleaning of textile floor coverings.
Use or storage in the open air under wet conditions.
Any operation of the machine when not in a technically perfect condition or if used without due regard for the following rules is prohibited:
Protective guards must not be dismantled nor bypassed.
Machine may be used only by trained staff.
Children or adolescents may not use the machine.
Conversion or modification of the machine is prohibited.
Only original schematics and documents must be used for maintenance and service.
2. Safety
2.1 Organisation
The operator is responsible for the following:
Operating instructions must be kept handy at all times.
All operators have read and understood the operating manual before using the machine.
In particular, all operators know the safety regulations and what they mean.
All operators have received training specific to the product in the use/handling of the machine.
Conducting periodic examinations of operators and their handling of the machine.
Ensuring that machine is used only by persons who have been expressly commissioned to use the machine.
Ensuring adherence to the acknowledged rules for occupational safety.
Ensuring adherence to any additional statutory or company regulations.
Clearly defining responsibilities for operation, maintenance and repair of the machine and ensuring that these responsibilities are
maintained.
Immediate notification of breakdowns and damage to the service agency.
2.2 Emergency
Apply First Aid immediately and/or summon help.
Switch off machine and remove key switch.
Do not operate machine after an incident – have machine examined by Wetrok or an approved representative!
2.3 Sources of danger
Voltage and current:
Contact with current or voltage carries the risk of electric shock, which can lead to injury or even fatality.
Before carrying out any work on electrical installations, always turn off the machine and isolate the battery voltage by disconnecting the battery
cable.
36

Publicité

Table des Matières
loading

Produits Connexes pour Wetrok iMatic XR85

Table des Matières