Intercom Panel Installation; Installing The Intelligent Bracket - THOMSON SMART 762 Mode D'emploi

Colour video interCom 18Cm
Connection from the contact with power supply (electric strike plate) to the intercom panel
Cable length
0 to 50 m

2 - INTERCOM PANEL INSTALLATION

• The intercom panel is designed to be installed
on a flat, vertical surface.
• Remove the wall mount from the rear of the
intercom panel.
• Attach the wall mount in the chosen location
using suitable screws and wall plugs for the
type of surface (the screws and plugs supplied
are suitable for solid walls).
• Cables can be fed through the hole in the
back of the bracket.
C - iNSTALLATiON
Section to use
0.75mm²

3 - INSTALLING THE INTELLIGENT bRACKET

• Remove the cover.
• Position the bracket in the chosen location
and check that it is in the optimum position for
connecting the cables.
• If the cables do not emerge directly from the
wall, break off the bottom plastic edge.
• Mount the intelligent bracket using suitable
screws and wall plugs for the type of bracket
(the screws and wall plugs provided are
suitable for solid walls).
EN EN
11