Velleman HQ POWER VDP250MH14 Mode D'emploi page 6

f. Function selection
Different functions can be set by means of the 3 push buttons and the display. When you switch the device on, the
display setting will be the same as before you turned it off.
Procedure: • Press the ENTER button for 3 seconds, the display will start flashing
• Press the UP button to select a different function
• Press ENTER to confirm the selected function or EXIT/DN to cancel
• The active function will flash. Switch it on or off using UP or EXIT/DN button
• Press ENTER again to confirm your settings
• Press EXIT/DN to save the setting and exit the menu
Please refer to the list below for the different settings:
S/N Function Option
display select
0
A A A A - - - - - - - - - - - - A001 ...A51 1
1
Run Run Run Run ON / OFF
2
Focu Focu ON / OFF
Focu Focu
3
Dis p Dis p DP - x
Dis p Dis p
4
RDIS RDIS RDIS RDIS ON / OFF
5
Rpan Rpan Rpan Rpan ON / OFF
6
Rt il t Rt il t Rt il t Rt il t ON / OFF
7
Res t Res t Res t Res t ON / OFF
8
Inda Inda Inda Inda ON / OFF
9
Lamp Lamp ON / OFF
Lamp Lamp
10
Ver Ver V – 1 .0
Ver Ver
11
Time Time Time Time OPEN
CLR
12
Tes t Tes t Tes t Tes t t E – 1
t E – 1 6
13
Cont Cont Cont Cont CN – X
14
Edit Edit Edit Edit SCE1
SCE1 5
6. Error Messages
When the device is switched on, it will make a reset first. The display may show "
or more channels. " " stands for any channel equipped with a position test sensor. For example, "
X
is an error in channel 2. Simultaneous errors on channels 1, 2 and 5 are shown as "
repeatedly for 5 times and then the device will reset all the stepper motors and generate a signal. If the errors remain
after 3 attempts, the device stop functioning if there are 3 or more errors. If there are less than 3 errors, the device
can still be operated with the exception of the erratic channels.
: Colour wheel error
1 1 1 1 Er r Er r Er r Er r
VDP250MH14
Return to main
menu
√
√
√
√
√
√
√
√
√
√
√
√
√
√
↓
√
Par -1
↓
Par -n
TIME
CNIN
Par l
↓
Par -N
TIME
CNIN
Display
DMX start address setting
Axxx
Run pre-installed programme in the EEPROM
RUN
Focus, opens the shutter, selects white light
Display the DMX value for each channel
Dxxx
Reverse display
Reverse pan
Reverse tilt
Reset
Install software into the EEPROM
Lamp ON/OFF control
Software version
Lamp work time (future releases only)
Xxxx
Reset lamp work time
Test the function of each channel
Edit a scene without controller
1 1 xx
↓
1 N xx
The run time of that scene
1 T – X
Edit a scene through a controller
ON/ OFF
↓
Edit a scene without controller
F 1 xx
↓
F N xx
The run time of that scene
F T – X
Edit a scene through a controller
ON/ OFF
6
Function explanation
" if there are problems with one
XERR
" means there
2Er r
", " ","
1Er r 2Er r 5Er r
" flashing
VELLEMAN