Velleman HQ POWER VDP250MH14 Mode D'emploi

VDP250MH14 – 14 CHANNEL 250W MOVING HEAD
1. Introduction & Features
Thank you for buying the VDP250MH14! It should come with a power cable, an XLR connection cable, a safety cable
and this manual. If the device was damaged in transit, don't install or use it and contact your dealer.
Please read the manual thoroughly before bringing this device into service.
The VDP250MH14 has the following features:
• Control signal: DMX-512, 14 channels
• 630° pan and 265° tilt rotation with adjustable speed and 8 or 16 bit resolution for smooth and precise motion
• electronic focus
• high speed dual blade shutter ; 0-15Hz or random strobe
• mechanically adjustable dimmer 100%~0%
• 1 colour wheel with 8 dichroic glass panes, rainbow effect + white
• 2 gobo wheels, 6 speed-adjustable rotating gobos + open, rainbow effect ; 7 fixed gobo's + open, rainbow effect
• gobo shake & gobo index
• lamp on, motor reset, lamp off
• 3-face speed adjustable prism rotates in 2 directions
• auto-programme: 8 pre-built programmes can be selected
• display: can turn 180° if required by the mounting location
• local or remote reset
• lamp switches ON/OFF locally
• auto test for all functions
• value of each DMX-channel can be displayed
• edit and save the programme to the incorporated EEPROM through the front control panel or external controller ;
can save maximum 15 scenes and run the saved programme by the "run" menu from the control panel.
2. Safety Instructions
Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
Do not touch the device during operation as the housing heats up.
Keep this device away from rain and moisture.
Unplug the mains lead before opening the housing.
• Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
• A qualified technician should install and service this device.
• Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature.
• This device falls under protection class I. It is therefore essential that the device be earthed. Have a qualified
person carry out the electric connection.
• Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.
• Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.
• Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
• There may be some smoke or a particular smell when the device is activated for the first time. This is normal and
any smoke or smell will gradually disappear.
• Do not look directly at the light source as sensitive people may go into epileptic seizure if they do.
• Note that damage caused by user modifications to the device is not covered by the warranty.
• Keep the device away from children and unauthorised users.
VDP250MH14 1 VELLEMAN