Bosch LR8 Consignes D'utilisation Et De Sécurité page 11

When no button is pressed on the tool for approx. 20 minutes
and when no laser beam reaches the reception area 5 for 20 min-
utes, the tool automatically switches off in order to save battery
power.
With button 2, you can specify with which accuracy the position
of the laser beam is indicated on the reception area:
– "Fine" adjustment (indication f on the display),
– "Coarse" adjustment (indication e on the display).
Whenever switching on the tool, the accuracy level "Fine" is set.
The position of the laser beam on the reception area 5 is indi-
cated:
– via the direction indicators "move downward" b, "move up-
ward" d or the center indicator c on the display 6 on the front
of the measuring tool,
– via the LEDs "move downward" 10, "move upward" 12 or the
center-indication LED 9 on the back of the tool,
– optionally via the audio signal (see "Audio Signal for Indication
of the Laser Beam").
Tool too low: When the laser beam runs through the top half of
the reception area 5, the direction indicator d on the display and
the corresponding direction LED 12 light up. When the audio
signal is switched on, a high frequency signal sounds. Move the
tool upward in the direction of the arrow.
Tool too high: When the laser beam runs through the bottom half
of the reception area 5, the direction indicator b on the display
and the corresponding direction LED 10 light up. When the audio
signal is switched on, a low frequency signal sounds. Move the
tool downward in the direction of the arrow.
Tool in center position: When the laser beam runs through the
reception area 5 at the center mark 11, the center indicator c on
the display and the corresponding center-indication LED 9 light
up. When the audio signal is switched on, a continuous signal
sounds.
2610050387 03-18 LR8.indd 11
Selecting the Setting of the Center Indicator
Direction Indicators
-11-
3/20/18 3:08 PM