hager RTN500X Manuel page 11

RTN500X
Quick start configuration
Quick start configuration with IP intercom server RTD110X
The quick start area is specifically adapted to the subnet configuration of the IP intercom server.
The components in the subnet should not be changed except for the adaptations described here.
www.hager.com Subject to technical changes
After calling up the Web inter-
face, select the "Quick start"
area and log in with the factory:
Username:
password:
on the IP door speaker module.
NOTE:
The video stream is always
retrieved through the main
network IP address of the
RTD110X server and the port
defined there for the camera.
Example: 192.168.178.42:8021/
mjpg/video.mjpg
Please be sure that the device/
client you are using supports
video playback (MJPEG) or
signal image display (JPEG). A
viewer account is predefined at
the factory:
Username:
Password:
If there are multiple inputs, con-
figure the camera modules at
the specific entrance and con-
!
firm your selection with "Save".
The IP address of the camera
module is now adapted to the
configuration defined in the IP
intercom server.
IMPORTANT:
In general, no further settings
will be necessary. For more de-
tailed information, please see
the current IP system manual.
admin
1234
camuser
view
11