AJAX Hub 2 Plus Manuel D'utilisation page 50

1. Attach the SmartBracket panel to the surface using bundled screws, using
at least two xing points (one of them — above the tamper). After selecting
other attachment hardware, make sure that they do not damage or deform
the panel.
The double-sided adhesive tape may be only used for temporary attachment of
KeyPad. The tape will run dry in course of time, which may result in the falling of the
KeyPad and damage of the device.
2. Put KeyPad on the attachment panel and tighten the mounting screw on the
body underside.
As soon as the KeyPad is xed in SmartBracket, it will blink with the LED
X (Fault) — this will be a signal that the tamper has been actuated.
If the malfunction indicator X did not blink after installation in SmartBracket,
check the status of the tamper in the
tightness of the panel.
If the KeyPad is torn off from the surface or removed from the attachment panel,
you will receive the noti cation.
KeyPad Maintenance and Battery Replacement
Check the KeyPad operating capability on a regular basis.
The battery installed in the KeyPad ensures up to 2 years of autonomous
operation (with the inquiry frequency by the hub of 3 minutes). If the KeyPad
battery is low, the security system will send the relevant notices, and the
malfunction indicator will smoothly lights up and goes out after each successful
passcode entry.
How long Ajax devices operate on batteries, and what affects this
Battery Replacement
Complete Set
Ajax app and then check the xing