Whirlpool WGD94HEXW Mode D'emploi page 9

CYCLE GUIDE — MANUAL CYCLES
Settings and options shown in bold are default settings for that cycle.
Not all features and cycles are available on all models.
Not all settings and options are available on each cycle.
Adjusting drying time on Manual Cycles
Check Lint Screen Sensing
Wet Damp
Down
When you select a Manual Cycle, the default
Estimated Time Remaining
High
time appears in the display. Use the s and t
Medium
Low More Dry
buttons to increase or decrease the time in 1
Extra Low Normal Dry
minute increments. Press and hold to change
Timed Dry Adjust
Air Only Less Dry
the time in 5 minute increments.
The maximum dry time is 100 minutes.
Cycle:
Items to dry:
Small loads and Quick Dry
sportswear
Any load Timed Dry
NOTE: Select Air
Only to dry foam,
rubber, plastic, or
heat-sensitive
fabrics.
Or Wrinkle Shield with Steam (on some models). Wrinkle Shield with Steam is available only with High and Medium Drying Temperature settings.
†
CYCLE GUIDE — STEAM CYCLES
Settings and options shown in bold are default settings for that cycle.
Not all settings and options are available on each cycle.
Steam cycles are designed for use with dry loads to loosen wrinkles, reduce odors, and refresh fabrics.
Items to
Cycle:
refresh:
Shirts, blouses, Quick Refresh
and slacks with Steam
Mixed Loads Enhanced
Touch Up
(on some
models)
* 12 minutes on 11-cycle models. 15 minutes on 8-cycle models.
Or Wrinkle Shield with Steam (on some models). Wrinkle Shield with Steam is available only with High and Medium Drying Temperature settings.
†
Load Size Recommendations
For best results, follow the load size recommendations noted for
each cycle.
Small load: Fill the dryer drum with 3-4 items,
not more than 1/4 full.
Cool Steam Static Done Wrinkle
Reduce Shield
8 - 9
6 - 7
4 - 5 Loud
2 - 3 Soft
1 O
Drying
Default
Temperature:
High
Medium
Low
Extra Low
Air Only
High
Medium
Low
Extra Low
Air Only
Drying
Default
Temperature:
Medium
High
Medium
Selecting the Drying Temperature
A High heat setting may be used for drying heavyweight items
such as towels and work clothes.
A Low to Medium heat setting may be used for drying
medium-weight items such as sheets, blouses, dresses,
underwear, permanent press fabrics, and some knits.
Use a no heat (air dry) setting for foam, rubber, plastic, or heat-
sensitive fabrics.
Line dry bonded or laminated fabrics.
NOTE: If you have questions about drying temperatures for
various loads, refer to the care label directions.
Available
Time: Options:
13 Wrinkle Shield
†
40 Wrinkle Shield
†
Available
Time: Options:
12 (15)*
Wrinkle Shield
†
Static Reduce
22
Wrinkle Shield
†
Static Reduce
Medium load: Fill the dryer drum up to about 1/2 full.
Large load: Fill the dryer drum up to about 3/4 full.
Do not overload. Items need to tumble freely.
Cycle Details:
For small loads of 3-4 items.
Use to dry items to a damp level for items that do
not require an entire drying cycle. Select a drying
temperature based on the type of fabrics in your
load. If you are unsure of the temperature to select
for a load, select the lower setting rather than the
higher setting.
Cycle Details:
Use to reduce odors and light wrinkles.
Select the number of garment to be refreshed
(on some models). Do not add dryer sheets.
Use to remove wrinkles, including from loads left in
the dryer too long. Dry time will automatically adjust
when the load size is sensed. Cycle run time cannot
be manually adjusted, but Temperature is selectable.
Do not add dryer sheets
9