Operation; Operation Instructions - Zipper Maschinen ZI-BM870ECO Manuel D'utilisation

15

OPERATION

15.1

Operation instructions

Check motoroil level before EVERY use.
If motoroil level is not max. fill motoroil up to the top of the oilfiller neck.
Check before every work the working area for hidden stones, tree trunks, etc. and
remove if possible, otherwise mark clearly.
Always mow in lines across the slope, working your way cutting line per cut-ting line
upwards the slope. Take especial care at the turning points.
Always adjust the forward speed to ground conditions.
15.2 Operation
Cold engine start-up
Bring the throttle lever 1 (Abb. A) into position:
Position yourself next to the machine with sufficient distance to the cutting bar.
Pull out energetically on the ignition knob2 (Fig.E1) and release it once the engine has started
After a few seconds, position the throttle lever in an intermediate position between the symbol and the
symbol
Hot engine start up
Put the throttle lever in an intermediate position between
Position yourself next to the machine with sufficient distance to the cutting bar.
Pull out energetically on the ignition knob2 (Fig.E1) and release it once the engine has started
Switching on the cutter bar
Unlock the safety catch 7 (Fig. A). Fully depress the cutting clutch lever 6 (Fig. A) and hold it down
tight. To switching off the cutter bar just release the cutting clutch lever 6 entirely.
Engaging the wheel drive
Depress the forward clutch lever 8 (Abb. A). Max. Forward speed is 2.5km/h at fully depressed lever.
To switching off the wheel drive just simply, release the lever entirely.
Switch machine off
Scythe mower in a position across the slope. Forward drive switched off Cutter bar switched off.
Now move the throttle lever to "O" position.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-BM870ECO
ATTENTION
OPERATION
.
.
24