Panasonic BT-H1700P Manuel D'instructions page 22

Compliant Signal Formats of Each Input Card
Input Signals
NTSC (3.58 MHz)
PAL (4.43 MHz)
Black-and-White (50 Hz/60 Hz)
480/60i (525i)
480/60p (525p)
576/50i
576/50p (*1)
720/60p (720p)
1080/50i (*1)
1080/60i (1125i) (*2)
1035/60i (1125i) (*1 *3)
1080/24psF (*4)
R : Input possible. Pre-set.
: Input possible. Not pre-set. Any adjustments required in some cases.
– : Input impossible
*1 : 1080/50i, 1035/60i and 576/50p are not pre-set. When these signals are input, some adjustments are required.
*2 : Including 1080/59.94i.
*3 : Including 1035/59.94i.
*4 : Including 1080/23.98psF.
APPENDIX: CONNECTION EXAMPLES FOR THE
This section explains the usage precautions and connection examples when using the SWITCHED OUT terminal of the SDI / HD
SDI input card.
Usage Precautions
● The selected signal is output from the SWITCHED OUT terminal only when the monitor's power is turned on.
● The output signal from the SWITCHED OUT terminal is the one that is selected from the signals input to SDI 1 / HD SDI 1 or
SDI 2 / HD SDI 2.
The table below shows the connection between the INPUT SELECT buttons (input signal selection) and the input/output of
the SDI / HD SDI input card.
Selected INPUT SELECT Buttons
A, C, E
B, D, F
22
BT-YA701P
R
R
R
—
—
—
—
—
—
—
—
—
SDI / HD SDI INPUT CARD
Signal Output from the SWITCHED OUT Terminal
Signal from SDI 1 / HD SDI 1
Signal from SDI 2 / HD SDI 2
BT-YA702P BT-YA703P
— —
— —
— —
R R
R —
R R
—
R —
—
R —
—
R —
BT-YA704P
—
—
—
—
—
—
—
R
R
R