Vermeiren EAGLE 620 Mode D'emploi page 18

3.2.3 Dismantling
WARNING: Risk of clamping - Take care that no body parts and wires get trapped,

crushed or cut during dismantling.
WARNING: Risk of injury - Check the emergency stop (red pushbutton on the

control box) is activated, to avoid unintentional adjustment movements.
1. Secure the two casters at the back of the chassis by
pressing the caster brake plates down gently to their
end stops with the tip of your foot. To release the
brake, push the brake plate gently back up again with
the front of your foot until the casters are free.
2. Move the cantilever arm to the bottom position (end
stop). Place the expanding bracket vertically and
secure it with the transport strap Velcro, as shown in
the picture.
3. Remove the safety spindle (locking pin) from the
bottom end of the pole by gently pressing the button
at the head of the spindle. The safety spindle can
now be removed easily.
WARNING: Risk of injury - Once the pole is
4.

unlocked, its own weight can cause
considerable downward forces to be
exerted.
Pull out the standing position safety (traction screw)
until the pole is released and can be tilted. The pole
can now be tilted forwards.
Tip the pole as far as possible forward that its head
end comes to rest on the expanding bracket.
5. WARNING: Risk of injury - Make sure that

the safety spindle is correctly inserted.
Fix the pole in place by pushing the safety spindle at
the end of the pole in with the pushbutton depressed
until its other end clearly protrudes. Release the
pushbutton on the safety spindle and check that it
cannot be pulled out again.
ƒ‰‡
Eagle
2011-09