Universal Remote Control - Sanyo AVM-2760S Manuel D'instructions

REAR PANEL
Cable / Antenna Input
Terminal (75 ohms)
Audio /Video Input Jacks
Connect external video
equipment here (see page 10).

UNIVERSAL REMOTE CONTROL

Operates your TV, VCR and Cable converter box. To familiarize yourself with this remote
control, see page 6. To program the remote control, see page 7.
INSTALLING BATTERIES (2 AA not included)
1. Remove the battery cover by pressing the tab and tilting
the cover upward. Insert batteries. Make sure you match
+
/ signs on the batteries with marks inside the
remote control.
2. Replace battery cover. The remote control is ready!
Notes:
– Do not mix old batteries with new ones or mix
different types of batteries together.
– Remove the batteries if the remote control will not be
used for a month or more. Weak batteries may leak and
cause damage.
IMPORTANT NOTE: Spent or discharged batteries must be recycled or disposed of
properly in compliance with all applicable laws. For detailed information, contact
your local County Solid Waste Authority.
UHF/VHF/CATV
75Ω
AUDIO VIDEO INPUT
R AUDIO
Audio Output Jacks (Fixed)
Connect external audio
equipment here (see page 10).
AUDIO
OUTPUT
L
L VIDEO
(MONO)
R
QuickTips
Make sure all cable
connectors are fully
seated on jacks.
See page 10 before
connecting external
video equipment.
Cables are not
supplied for connect-
ing your external
equipment.
A solid Blue screen
with the word Video
displayed means that
the Video mode is
selected, but no
signal is being
detected at the
Video jack. Check
connection, and
turn on external
equipment.
Be sure batteries are
installed correctly.
Point the remote
control toward the
equipment you want
to control. Objects
between the remote
control and the
equipment may cause
misoperation of the
remote control
function.
5