Using The Multimedia Remote Control - Sanyo DS27930 Manuel D'instructions

USING THE MULTIMEDIA REMOTE CONTROL

Operates your TV, VCR, DVD, Cable converter box, and Satellite Receiver. To program
the remote control, see pages 9 ~ 11.
INSTALL BATTERIES AS SHOWN (2 AA, not included)
Notes:
– Do not mix old batteries with new ones or mix different types of
batteries together.
– Remove the batteries if the remote control will not be used for a
month or more. Weak batteries may leak and cause damage.
(Normal battery life is roughly six months.)
IMPORTANT NOTE: Spent or discharged batteries must be recycled or disposed
of properly in compliance with all applicable laws. For detailed information,
contact your local County Solid Waste Authority.
REMOTE CONTROL KEYS
Mode Keys—Use these keys to program the
remote control and to select the operating mode
(VCR, TV, CABLE, DVD, SAT, or AUX). To
Operate Your... VCR—Press the VCR key;
Television—Press the TV key; Cable Box—Press
the CABLE key; DVD Player—Press the DVD key;
and Satellite Receiver—Press the SAT key.
Note: Make sure you hold down the mode key
while entering a code number, see page 9.
Input Key—In the TV and Satellite modes, this
key selects the program source to display on the
screen (TV signal or signal from equipment con-
nected to the AV jacks). In the VCR mode, this key
functions as a VCR's TV/VCR key.
Number Keys—Two keys must be pressed to select
a channel. Example: Press 0 then 6 to select channel
6. For cable channels 100 through 125, press and
hold the 1 key until C1–– appears. Then press the
other two numbers.
Caption Key—See page 17.
All manuals and user guides at all-guides.com
CABLE
VCR TV
DVD SAT AUX
POWER
INPUT RESET
2 3
1
4 5 6
7 8 9
0
CAPTION SLEEP
MENU RECALL
CH
VOL VOL
CH
DISPLAY
MUTE
(Continued on page 8.)
QuickTips
Be sure batteries are
installed correctly.
Point the remote
control toward the
equipment you want to
operate. Objects bet-
ween the remote
control and the equip-
ment may cause
misoperation of the
remote control
function.
If the remote control
does not work: Press
TV key (see item 1).
The remote control
must be programmed
before it will operate
your VCR, DVD
Player, Satellite
Receiver, or Cable
Box. See pages 9~11.
Note: Sanyo's VCR
and DVD codes are
preprogrammed.
Cannot select
channel with number
keys. Press "0"in
front of numbers 1~9.
Example: Channel 05.
Adjusting the volume
level: Flashing Right
arrow indicates
volume is increasing
and flashing Left
arrow indicates
volume is decreasing.
Need help?
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
7